Students Name:
	In your NC program:	YES	NO
1	Is there a 4 digit “O” word at the top of the program
2	Is there a Safety start block at the beginning of each operation
3	Did you put comments into your program
4	Does the H and D number match the tool number
5	Make sure to position in X and Y before moving down in Z
6	Is your " H"with the first Z move
7	Are there M1’s in your program, to check the coolant
8	Are the M1 commands before, not after the M3 command
9	Did you turn the coolant on in your program, for each operation
10	Did you calculate your RPM for each tool (c.s. X 12) / (? X dia)
11	Did you calculate your feed for each tool (RPM X CPT X No. teeth)
12	Did you put an M6 before the M1 at the end of each operation
13	Are there M1’s at the end of each operation
14
15
14	Is there an M2 at the end of the program
12
	On the Machine:
1	Do you have your safety glasses on
2	Did you check the oil level
3	Did you check the air pressure
4	Did you check the coolant level
5	Did you reinitialize the memory, or clear out the old programs, if needed
6	Did you Cold Start the machine properly
7	Did you load the correct program into the machine
8	Did you set your Part X & Y zero correctly,
9	Did you compensate for half the dia. of the edge finder in X & Y
10	Are the tools in the correct order
11	Did you measure the tool diameters correctly
12	Did you enter the diameters into the tool table
13	Did you set the length of each tool , and modify it, if required
14	Did you verify the length offset of each tool
15	Did you type PA to verify you have loaded the correct program
16	Did you type SU to check your program
17	Did you Inspect the part in the Machine BEFORE removing it !
18	Did you clean the machine, and put the tools away
19	Did you set the machine back to the home position